 |
 |
 |
|
New for 2010, the introduction of the VLTOR Improved Modstock, appropriately named the “IMod”. Since 2002, the original Modstock has become well known and respected by Military, Law-Enforcement and sports shooters worldwide. Even though the Modstock is considered the best on the market, Vltor believed it was time for improvements. The improvements are subtle but necessary. Feedback from end users will make the IMod the choice over the competition.
Like all Vltor stocks, the IMod is available in the three most popular colors; Black, Flat Dark Earth (tan) and Foliage Green. As with the original Modstocks, the IMod is offered in the conventional, “Standard” configuration and the unconventional, “Clubfoot” configuration. Even though the Standard model is the most well-known model amongst the shooting public, the Clubfoot version is a hybrid model that bridges the gap between tactical and prone shooting positions. In other words, the Clubfoot portion of the stock allows the shooter, with his/her off hand, to support the stock and to control the rear of the weapon, while shooting in prone or rested position.
The improvements of the IMod are as follows:
Integral, but removable non-slip buttpad (color matched to stock components)
Rolled/angled buttpad toe with wide traction area. This will assist in running the stock high on shoulder, making the IMod system more user friendly when using web-gear and/or body armor.
Improved lock paddle, making it easier to operate and making the contact surface non-slip when operating the lever.
Removed most sharp edges that may cause “snag points” to web-gear or other vital equipment.
Improved strength throughout construction of the stock chassis. This will provide maximum strength during “Mortaring exercise” or unexpected impact.
Integral, but removable non-slip buttpad (color matched to stock components)
Commercial size will fit the following AR-15 type rifles equiped with a commercial size buffer tube: DMPS, Rock River Arms, Bushmaster and all others with commercial diamter buffer tube. Also available in Mil-Spec size |
|
|
|
|
|
 |
|
 |
|
Features
- Removable rubber buttpad and storage compartments
- A true Modular buttstock for the AR15/M16/M4 carbine series
- Impact and temperature resistant polymer, specially blended for Vltor
- Metal components are either carbon steel or stainless steel (depending on the application)
- Milspec IMods will only fit receiver extensions/buffer tubes with the outer diameter of 1.150”, while Commercial IMods will only fit 1.170” diameter receiver extensions
- Light weight, less than 9.4 oz. (Milspec and Commercial with storage compartment and buttpad installed)
- Length: 6.250” (without buttpad)
- Length: 6.626” (with buttpad)
- Width: 2.500” (with storage compartments installed)
- Height: 5.210” (with buttpad installed)
- All stocks have a matte (anti-reflection/glare) finish
- IMods are only available in the following colors: Black, Flat Dark Earth (Tan) and Foliage Green
- Each side compartment can hold at least two AAs or three lithium CR123 3-volt batteries
- All Modstocks, including the IMod will accept a push-button, quick detachable sling swivel or a conventional web sling, measuring up to 1.375” in width
|
|
|
 |
|
 |
|
|
|
