 |
 |
 |
|
The PWS Enhanced Buffer Tube is an impact extruded 6061 aluminum version of the original billet 7075 aluminum buffer tube. This version was designed as a more cost effective alternative to the original. The Enhanced Buffer Tube will resolve any carrier tilt symptoms exhibited by a short stroke piston AR and will reduce felt recoil.
The most notable features on this buffer tube include:
1. One piece construction eliminating the castle nut and ensuring that when installed, the buffer tube cannot become loose.
2. Attachment system automatically indexes the buffer tube perfectly straight.
3. The bottom of the interior buffer tube extends a lip into the receiver, supporting the bottom rear of the bolt carrier, reducing the carrier tilt present in some piston systems.
4. A dead blow buffer is securely installed in the rear of the buffer tube to reduce carrier speed by an average of 10%, and dramatically reduce felt recoil.
5. Two QD sling swivel attachments are machined into the front of the buffer tube allowing ambidextrous connection of your QD slings.
6. The buffer tube is fluted to allow debris to be pushed out of the way, and a drain hole has been placed in the bottom of the tube, allowing for draining of water when the rifle is parallel to the ground.
For use on Mil-Spec AR-15/M16 based lower recievers and/or weapons platforms.
The PWS Enhanced Buffer Tube is Mil-Spec. |
|
|
|
|
|
 |
|
 |
|
Features
- 6061 T6 Aluminum Construction
- Length 7.8" (19.8 cm)
- Diameter 1.15" (2.9 cm)
- Width 1.8" (4.5 cm) at QD points
- Weight 5.5 oz (156 grams)
- Made in U.S.A.
|
|
|
 |
|
 |
|
|
|
